Part Number (MPN)
13537066
UPC / GTIN
193468494266 / 00193468494266
Abutment Clips Included
No
Anti-Rattle Spring Included
No
Bleeder Screw Included
Yes
Bleeder Screw Thread Size
M10
Caliper Slides Included
No
Casting Material
Cast Iron
Disc Brake Caliper Casting Material
Cast Iron
Features & Benefits - Bullet 1
Some GM Genuine Parts may have formerly appeared as ACDelco GM Original Equipment (OE)
Features & Benefits - Bullet 2
GM Genuine Parts are designed, engineered and tested to rigorous standards, and are backed by General Motors
Features & Benefits - Bullet 3
GM Engineers design and validate OE parts specifically for your Chevrolet, Buick, GMC, or Cadillac vehicle
Features & Benefits - Bullet 4
GM regularly updates production and service part designs to integrate new materials and technologies
Good Maintenance Practices - Section 1 - Bullet 1
Check brake fluid level at every oil change. Replace fluid according to owner's manual recommendations.
Good Maintenance Practices - Section 1 - Bullet 2
Calipers and wheel cylinders should be checked every brake inspection and serviced or replaced as required.
Good Maintenance Practices - Section 1 - Bullet 3
Inspect the brake lines for rust, punctures, or visible leaks (You may be able to do this, but consult a qualified technician if necessary).
Good Maintenance Practices - Section 1 - Bullet 4
Check the thickness of your brake pads.
Good Maintenance Practices - Section 1 - Header
The following inspections and maintenance procedures can help prevent potential brake problems.
Good Maintenance Practices - Section 2 - Bullet 1
Inspection of the brake hoses for brittleness or cracking.
Good Maintenance Practices - Section 2 - Bullet 2
Inspection of brake lining and pads for wear or contamination by brake fluid or grease.
Good Maintenance Practices - Section 2 - Bullet 3
Inspection of wheel bearings and grease seals.
Good Maintenance Practices - Section 2 - Bullet 4
Parking brake adjustments (as needed).
Good Maintenance Practices - Section 2 - Header
The following should be conducted by a qualified technician:
Inlet Fitting Type
Straight
Mounting Bracket Included
No
Mounting Hardware Included
No
Mounting Hole Diameter
0.32<br />8.1
Pad Wear Sensor Included
No
Piston 1 Diameter (in)
2.01
Piston 1 Diameter (mm)
51.08
Signs of Wear & Troubleshooting - Section 1 - Bullet 1
Vehicle pulls to the left or right when brakes are applied.
Signs of Wear & Troubleshooting - Section 1 - Bullet 2
Brake pedal pulsation (not to be confused with normal ABS operation).